TIG Welding

The tungsten kept dipping into the puddle, the filler rod stuck at the worst moments, and every mistake showed up […]

Running a clean weld on thin stainless or aluminum can get frustrating fast when the heat starts spreading too much

Nothing humbles a TIG welder faster than watching a beautiful bead crack because the filler rod was wrong for the

Everything can seem perfectly dialed in during a TIG weld—the tungsten is sharpened, the gas is flowing, and the settings

Hot metal popping, filler rod sticking when it shouldn’t, and a weld bead that just didn’t look right — that’s

The arc kept wandering, the tip of the tungsten looked dull instead of forming a clean ball, and the puddle

Switching between 0.030-inch sheet and 1/4-inch plate in the same project creates instant problems: burn-through on the thin side or

TIG welding without foot pedal is a common requirement in field fabrication, pipe installation, and situations where pedal control isn’t

The puddle stayed tight, the edges didn’t collapse, and the heat felt controlled instead of overwhelming. Aluminum usually runs away

The arc kept wandering, the puddle looked cloudy, and the tungsten was burning up faster than it should. Everything else

The arc kept washing out the edges of the joint, even though my torch angle felt right. I backed off